Appendix D: Classic Division
This is no more than a standard division in single stack... No point!
If a single stack division is wished, it should be based on the history, and
if I am not mistaken, single stack guns are Colt firearms based. By the
history, those guns were manufactured in 38 Auto ( 1900), .45 ACP( in 1905
maybe before ) and 9mm ( around 1920).
So we believe that major caliber should be .45 ACP and minor should be
minimum 9mm caliber.
No slide porting or barrel porting
No electronic sight and no optic fiber sight ( Optic fiber was not existing
in the 1900 years )
No bull barrel
mag capacity of 10 rounds max, but mag tube must not be longer than frame
while being inserted in the gun. Base pads increasing capacity are
prohibited.
Regarding magwell, either we let the use of magwells, but no restriction
needed about sizes ( it makes another control to be done, and slows down
once more the gun check) it has to fit the box. Or either the use of magwell
is prohibited.
Agree for power factors lines
Agree for having the gun tested inside the box with empty mag inserted.
100% съм съгласен с Ерик( Ерик кой?)
в противен случай няма нужда да я правят защото ще е много близка до СтД и едихстжената разлика ще е едноредовия пълнител...което не кой знае колко голянма разлика ако събира 9 патрона в .40 калибър например